Lantronix XPress DR+ Manuel d'utilisateur Page 66
- Page / 116
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
XPress DR+ User Guide 66
Chapter 8: Setup Mode: Server Configuration
This chapter explains how to configure the network settings for the XPress DR+ and
XPress DR+W.
Server Configuration (Option 0)
You can configure the unit’s basic network parameters when you select Server
configuration (option 0).
Note: Current values display in parentheses.
Network Mode (XPress DR+W only)
The first prompt requires you to set the unit for wired or wireless use. Wired is the
default.
Figure 8-1. Network Mode
The IP Address, Set Gateway IP Address, and Netmask fields display the current
values.
Figure 8-2. Server Settings
IP Address : (000) .(000) .(000) .(000)
Set Gateway IP Address (N)
Netmask: Number of Bits for Host Part (0=default) (0)
Change telnet config password (N)
IP Address
If DHCP is not used to assign IP addresses, enter the IP address manually. The IP
address must be set to a unique value in the network. Enter each octet and press Enter
between each section. The current value displays in parentheses.
IP Address : (000) (000) (000) (000) _
If DHCP is used, the third octet of the IP address sets the BootP/DHCP/AutoIP options.
The following table shows the bits you can manually configure to force the XPress DR+
to disable AutoIP, DHCP, or BootP. To disable an option, set the appropriate bit.
- XPress DR+ 1
- User Guide 1
- Copyright & Trademark 2
- Contacts 2
- Disclaimer & Revisions 2
- Contents 3
- Figures 8
- Chapter 1: Using This Guide 10
- Additional Documentation 11
- Chapter 2: Introduction 12
- Addresses and Port Numbers 16
- Configuration Methods 17
- What's in the Box? 18
- XPress DR+ Front Panel 19
- Serial Interface 20
- Serial Connector Pinouts 21
- Ethernet Interface 23
- Power Requirements 24
- Reset Switch 24
- Power/Diagnostic LED 25
- Dimensions 26
- Wall Mount Bracket 27
- Product Information Label 27
- Chapter 4: XPress DR+W 28
- Ad Hoc Network 29
- Front Panel Description 31
- Hardware Address 32
- IP Address 32
- WLAN Settings 33
- Set Gateway IP Address 34
- Change DHCP Device Name: 35
- Topology 36
- Network Name (SSID) 36
- Adhoc Network Channel 36
- WPA2/802.11i 39
- Fixed or Automatic Data Rate 39
- Next Steps 40
- Installing DeviceInstaller 41
- Assigning an IP Address 41
- XPress DR+ User Guide 43 43
- Setting Description 43
- XPress DR+ User Guide 44 44
- Network Configuration 46
- Server Configuration 48
- Advanced 49
- Host List Configuration 50
- Channel Configuration 51
- Channel 1 52
- Port Settings 52
- Pack Control 53
- Connection Settings - TCP 54
- Connect Protocol 55
- Endpoint Configuration 55
- Connection Settings - UDP 56
- Datagram Mode 57
- XPress DR+ User Guide 59 59
- XPress DR+ User Guide 60 60
- Wireless Network Security 61
- WEP Options 61
- WPA Options 61
- Applying Settings 62
- Applying Factory Defaults 62
- Port (Setup Mode) 63
- Serial Port Connection 64
- Exiting Setup Mode 65
- DHCP Name 68
- Baudrate 69
- I/F (Interface) Mode 70
- Port Number 71
- Connect Mode 72
- 0 0 1 1 1 1 73
- 0 0 1 1 1 0 73
- XPress DR+ User Guide 74 74
- Auto Increment Source Port 78
- Remote IP Address 78
- Remote Port 79
- DisConnMode 79
- Packing Interval 81
- Trailing Characters 81
- Send Characters 81
- Telnet Terminal Type 82
- Channel (Port) Password 82
- Transmission Data Rate 86
- Enable Power Management 87
- Expert Settings (Option 5) 88
- Security Settings (Option 6) 89
- Disable SNMP 90
- SNMP Community Name 90
- Disable Telnet Setup 90
- Disable Port 77FE (Hex) 90
- Default Settings (Option 7) 91
- Expert Settings 92
- Security Settings 92
- Obtaining Firmware 93
- Reloading Firmware 93
- DeviceInstaller 94
- Chapter 12: Monitor Mode 96
- XPress DR+ User Guide 98 98
- Response Meaning 98
- Support 99
- XPress DR+ User Guide 100 100
- XPress DR+ User Guide 101 101
- Technical Support 102
- Category Description 103
- XPress DR+ User Guide 105 105
- AutoIP 106
- ARP and Telnet 107
- Conversion Table 108
- Scientific Calculator 108
- Declaration of Conformity 110
- Supplementary Information 111
- Manufacturer’s Contact 111
- Appendix F: Warranty 115
- XPress DR+ User Guide 116 116
Produits connexes et manuels pour Mise en réseau Lantronix XPress DR+
(8 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.038 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels