Lantronix Device Server UDS 10 Manuel d'utilisateur télécharger pdf (Page 40)

Getting Started

2-12

UDS-10 User Guide

2.6 Serial Port Login

If you want to initially configure the unit through a serial connection, follow these steps:

1. Connect a console terminal or PC running a terminal emulation program to your unit's

serial port. The default serial port settings are 9600 baud, 8 bits, no parity, 1 stop bit, no

flow control.

2. To enter Setup Mode, cycle the unit's power (power off and back on). After power-up,

the self-test begins and the red Diagnostic LED starts blinking. You have one second to

enter three lowercase x characters.

Note: The easiest way to enter Setup Mode is to hold down the x key at the terminal (or

emulation) while powering up the unit.

3. At this point, the screen display is the same as when you use a Telnet connection. To

continue with a serial port login, go to Using a Telnet Connection on page 3-10.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 138 139

Pas de commentaire

Lantronix Device Server UDS 10 Manuel d'utilisateur Page 40