Lantronix Printer LPS1-T Manuel d'utilisateur télécharger pdf (Page 13)

Installation Installing the MPS

2-3

5 Allow 45 seconds for the unit to fully boot. The LINK LED will be lit if there is a

valid network connection. The ACT LED gives information about what the MPS is

doing; for example, when code is being downloaded as the unit boots, the LED will

blink green quickly. If you have connected a 100BASE-T cable (MPS100 only), The

Link and 100MBit LEDs should both be solid green. If not, check your network con-

nection.

6 Print a Test page by pressing the Test/Reset button.

Note: If the Power LED does not light or the Test page does not print, refer

to Appendix B.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 73 74

Pas de commentaire

Lantronix Printer LPS1-T Manuel d'utilisateur Page 13