Lantronix Server 900-653-R Manuel d'utilisateur télécharger pdf (Page 31)

5: Configuration Using Web Manager

xDirect User Guide 31

3. When you are finished, click the OK button.

4. On the main menu, click Apply Settings.

Connection Settings - TCP

To configure a channel’s TCP settings:

1. On the main menu, click Connection. The Connection Settings window for the channel

displays.

Figure 5-7 TCP Connection Settings

2. In the available fields, enter or modify the following information:

Connect Protocol

Connect Mode: Passive Connection

At Time of Disconnect Select Yes to clear the output buffer when the network connection to or

from the device is disconnected. The default setting is No.

Protocol From the drop-down menu, select TCP.

Accept Incoming Select Yes to accept incoming connections. The default setting is Yes.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 81 82

User Guide 1
Copyright & Trademark 2
Warranty 2
Contacts 2
Disclaimer 2
Revision History 2
Table of Contents 3
1: Using this Guide 10 3
2: Introduction 12 3
4: Using DeviceInstaller 18 3
10: Firmware Upgrades 61 6
11: Monitor Mode 64 6
List of Figures 8
List of Tables 9
1: Using this Guide 10
Additional Documentation 11
2: Introduction 12
Protocol Support 14
Additional Features 14
Configuration Methods 14
Product Information Label 15
3: Installation of xDirect 16
Required Information 17
4: Using DeviceInstaller 18
Next Step 21
Network Configuration 24
Ethernet Configuration 25
Server Configuration 26
Host List Configuration 28
Channel 1 Configuration 29
Pack Control 30
Connection Settings - TCP 31
Endpoint Configuration 32
Common Options 32
Connection Settings - UDP 33
Apply Settings 35
Apply Defaults 35
Accessing Setup Mode 36
Exiting Setup Mode 38
IP Address 39
Set Gateway IP Address 40
Set DNS Server IP Address 40
DHCP Name 41
Channel 1 (Option 1) 42
Baudrate 42
I/F (Interface) Mode 43
Port Number 44
Connect Mode 44
Host List Option (Hostlist) 47
Auto Increment Source Port 51
Remote IP Address 51
Remote Port 51
Flush Mode (Buffer Flushing) 52
Send Characters 54
Telnet Terminal Type 54
Channel (Port) Password 54
Expert Settings (Option 5) 55
Security Settings (Option 6) 56
Disable SNMP 57
SNMP Community Name 57
Disable Telnet Setup 57
Default Settings (Option 7) 59
Expert Settings Defaults 60
Security Settings Defaults 60
10: Firmware Upgrades 61
Figure 10-2 TFTP Window 62
11: Monitor Mode 64
Monitor Mode Commands 65
Status LED 67
Problems and Error Messages 68
 The hardware address you 69
 The IP address you are 69
 You did not choose the 69
Technical Support 71
Serial Port Pinouts 72
Ethernet Connector Pinouts 73
Power Jack (Mini USB-B) 74
ARP and Telnet 78
Conversion Table 79
Scientific Calculator 79
Appendix F: Compliance 81
Appendix F: Compliance 82

Commentaires sur ces manuels

Pas de commentaire

Lantronix Server 900-653-R Manuel d'utilisateur Page 31

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Lantronix Server 900-653-R