Lantronix Server 900-653-R Manuel d'utilisateur télécharger pdf (Page 66)

11: Monitor Mode

xDirect User Guide 66

Note: Entering any of the commands listed above generates one of the following

command response codes:

Table 11-3 Command Response Codes

co Set IP address, host

bits, gateway, and DNS

server IP

Example:

co 192.168.0.10 8 192.168.0.1 10001 192.168.1.10

with

192.168.0.10 = IP address of the xDirect

8 = number of host bits

192.168.0.1 = gateway IP address

10001 = port number of the xDirect

192.168.1.10 = IP address of the DNS Server

The xDirect stores the setup and performs a reset. It

sends an X before the reset if the command was OK.

Response Meaning

0> OK; no error

1> No answer from remote device

2> Cannot reach remote device or no answer

8> Wrong parameter(s)

9> Invalid command

Command

(continued)

Command Name Function

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 81 82

User Guide 1
Copyright & Trademark 2
Warranty 2
Contacts 2
Disclaimer 2
Revision History 2
Table of Contents 3
1: Using this Guide 10 3
2: Introduction 12 3
4: Using DeviceInstaller 18 3
10: Firmware Upgrades 61 6
11: Monitor Mode 64 6
List of Figures 8
List of Tables 9
1: Using this Guide 10
Additional Documentation 11
2: Introduction 12
Protocol Support 14
Additional Features 14
Configuration Methods 14
Product Information Label 15
3: Installation of xDirect 16
Required Information 17
4: Using DeviceInstaller 18
Next Step 21
Network Configuration 24
Ethernet Configuration 25
Server Configuration 26
Host List Configuration 28
Channel 1 Configuration 29
Pack Control 30
Connection Settings - TCP 31
Endpoint Configuration 32
Common Options 32
Connection Settings - UDP 33
Apply Settings 35
Apply Defaults 35
Accessing Setup Mode 36
Exiting Setup Mode 38
IP Address 39
Set Gateway IP Address 40
Set DNS Server IP Address 40
DHCP Name 41
Channel 1 (Option 1) 42
Baudrate 42
I/F (Interface) Mode 43
Port Number 44
Connect Mode 44
Host List Option (Hostlist) 47
Auto Increment Source Port 51
Remote IP Address 51
Remote Port 51
Flush Mode (Buffer Flushing) 52
Send Characters 54
Telnet Terminal Type 54
Channel (Port) Password 54
Expert Settings (Option 5) 55
Security Settings (Option 6) 56
Disable SNMP 57
SNMP Community Name 57
Disable Telnet Setup 57
Default Settings (Option 7) 59
Expert Settings Defaults 60
Security Settings Defaults 60
10: Firmware Upgrades 61
Figure 10-2 TFTP Window 62
11: Monitor Mode 64
Monitor Mode Commands 65
Status LED 67
Problems and Error Messages 68
 The hardware address you 69
 The IP address you are 69
 You did not choose the 69
Technical Support 71
Serial Port Pinouts 72
Ethernet Connector Pinouts 73
Power Jack (Mini USB-B) 74
ARP and Telnet 78
Conversion Table 79
Scientific Calculator 79
Appendix F: Compliance 81
Appendix F: Compliance 82

Commentaires sur ces manuels

Pas de commentaire

Lantronix Server 900-653-R Manuel d'utilisateur Page 66

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Lantronix Server 900-653-R