Lantronix Switch XSENSO 2100 Manuel d'utilisateur télécharger pdf (Page 38)

5: Installation of xSenso 21R2

xSenso User Guide 38

To reboot the unit without resetting the unit to factory defaults:

1. Place the end of a paper clip or similar object into the RST (reset) opening (see Figure 5-2)

and press and hold down micro switch during a power cycle for 3 to 5 seconds.

2. Remove the paper clip to release the button. The unit will reboot.

Side Panels

The following are located on the side panels (Figure 5-6):

Left Side

 Analog Input 1

 Analog Input 2

 9-30 VDC 3 Pin Terminal Block Power Input

 9-30 VDC Barrel Locking Power Input

Right Side

 Relay Output 1

 Relay Output 2

Figure 5-6 xSenso, Side Views

Back Panel

On the xSenso back panel, there is a mounting bracket with a sliding orange clip which allows you

to mount and dismount the device from a DIN rail, as shown in Figure 5-7. There are also four

rubber feet that can be attached to the bottom-side of the device, if the xSenso is to be placed on

a flat surface.

9-30 VDC Barrel

Locking Power Input

Excitation Voltage Input

Current Input

Relay 1 Relay 2

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 124 125

Pas de commentaire

Lantronix Switch XSENSO 2100 Manuel d'utilisateur Page 38