Lantronix SCS1620 Guide de l'utilisateur télécharger pdf (Page 38)

SCSxx05/SCSxx20 User Guide 3: Quick Start

3-2

Method #1 – Using the Front Panel Display

You can use the front panel display and pushbuttons to set up the basic network

interface. The system administrator can then access the SCS using your existing

IP network.

Figure 3-1. Front Panel LCD Display and Five Pushbuttons

(Enter, Up, Down, Left and Right)

The front panel display initially shows the server name (e.g., SCS4805) and the

date and time. Using the five pushbuttons, you can change the IP Address,

subnet mask, gateway, and DNS settings; date/time and time zone features; and

terminal port baud rate settings.

Note: Have your information handy as the display will time out without

accepting any unsaved changes if you take more than 30 seconds

between entries.

Once you save the values for your network, the network subsystem restarts (the

front panel display indicates “restarting”), after which the network connection

becomes active.

Navigating

The front panel has one ENTER button and four arrow buttons (up, left, right, and

down). Press the arrow buttons to navigate from one option to another, or to

increment or decrement a numerical entry of the selected feature. Use the

ENTER button to select an option to change or to save your settings.

Note: Some models have a SELECT button instead of an ENTER

button. The instructions are the same for using the SELECT button.

Entering the Settings

1. To change the front panel settings, press the right arrow on the front panel to

enter the display programming mode and to scroll between the available

options. Options include:

 Network Settings

 Terminal Settings

 Release Date

 Time/Date Settings

 Return to normal display

2. In this example, stop at Network Settings.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 140 141

Pas de commentaire

Lantronix SCS1620 Guide de l'utilisateur Page 38