Lantronix XPort AR Manuel d'utilisateur Page 21

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 156
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 20
4: Configuration Using Web Manager
XPort AR User Guide 21
Note: Both the IP and MAC addresses are required for the ARP cache.
Current State
Clear Select Clear to remove all entries in the ARP table.
Remove
Removes a specific entry from the ARP table.
3. Click Submit after each modified field. Changes are applied immediately to the
XPort AR.
PPP
Point-to-Point Protocol (PPP) establishes a direct connection between two nodes. It
defines a method for data link connectivity between devices using physical layers
(such as serial lines).
The XPort AR supports two types of PPP authorization: Password Authentication
Protocol (PAP) and Challenge Handshake Protocol (CHAP). Both of these
authentication methods require the configuration of a username and password. It
also supports no authentication scheme when no authentication is required during
link negotiation.
Note: The following section describes the steps to configure PPP 1 (PPP on serial
line 1); these steps also apply to PPP 2.
To configure the XPort AR’s PPP configuration:
1. Click Network Æ PPP Line 1 from the navigation menu. The PPP – Line 1
window displays.
Figure 4-4. PPP Settings
2. Enter or modify the following fields:
Mode Select Enabled to enable PPP on the XPort AR’s serial line 1.
Local IP Address
Enter the IP address assigned to the device’s PPP interface.
Vue de la page 20
1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 155 156

Commentaires sur ces manuels

Pas de commentaire