Lantronix UDS100 Manuel d'utilisateur télécharger pdf (Page 14)

This chapter describes how to get your UDS up and running in the shortest possible

time.

Installing the UDS

Figure 3-1. UDS Connected to Serial Device and Network

To install the unit, complete the following steps in order. Refer to the numbers in the figure

above.

1. Connect a serial device to your unit. See 9: Connections and Pinouts for more

information about the device attachments the unit supports.

2. Connect an Ethernet cable to the RJ45 port.

3. Supply power to your unit using the power supply that was included in the

packaging.

Note: The required input voltage is 9-30 VDC or 9-24 VAC

(1 W maximum).

4. Supply power to the serial device.

Note: If you encounter a problem, please see LEDs on page 45 for

diagnostic information.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 77 78

Pas de commentaire

Lantronix UDS100 Manuel d'utilisateur Page 14