Lantronix MPS100 Guide d'installation Page 129

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 223
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 128
Command Reference Monitor
12-9
baudrate
Enter the port’s baud rate, which can range from 150 to 115,200 baud.
parity
Enter the port’s parity, which can be Even, Odd, Mark, Space, or None.
charsize
Enter the character size, which can be either 7 or 8.
stopbits
Enter the desired stop bit count, which can be either 1 or 2.
Examples
Local> MODE COM4:9600,even,1,7
See Also Set/Define Port Commands, beginning on page 12-15.
12.15 Monitor
Monitor commands are the same as Show commands, except that the displayed information is continuously
updated approximately every three seconds. The display can be stopped by pressing any key. See the
corresponding Show commands for details and options.
12.16 Netstat
The Netstat command shows the currently active network connections. Information is displayed for the
AppleTalk, LAT, LAN Manager, NetWare and TCP/IP protocols. This information is primarily meant for
debugging network problems.
Applies To EPS1, EPS2, EPS2-100, EPS4-100, MPS1, MPS100, LPS1
12.17 Ping
Ping sends a TCP/IP request for an echo packet to another network host and therefore provides an easy way
to test network connections. In general, any host that supports TCP/IP will respond if it is able, regardless
of login restrictions, job load, or operating system. If there is no reply from the host, there may be a network
or TCP/IP configuration problem.
Applies To EPS1, EPS2, EPS2-100, EPS4-100, MPS1, MPS100, LPS1
NETSTAT
PING hostname
Vue de la page 128
1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 222 223

Commentaires sur ces manuels

Pas de commentaire