Lantronix MPS100 Guide d'installation télécharger pdf (Page 39)

Server Configuration LAT Server Parameters

4-3

4.3 LAT Server Parameters

Two groups of LAT parameters can be specified in order for the Server to communicate on the network: the

Server’s identification information (its identification string and name) and network timers. In addition, a

node limit can be set if desired.

4.3.1 Server Identification

Select a short, unique and descriptive name for the Server, as well as a more descriptive string to be used as

the identification string. The name may contain up to 16 characters and the identification string may contain

up to 40 characters.

Figure 4-4: Defining Server Name

Note: If you change the Server name, be sure to echo the change in any existing

NetWare print setups.

4.3.2 Network Timers

The LAT network timers (Circuit, Keepalive, and Multicast) as well as the Retransmit Limit are set to

default values at the factory and are correct for most networks. They should be changed only if you are sure

the change is necessary.

Figure 4-5: Changing LAT Parameters

4.3.3 Node Limit

The Set/Define Server Node Limit command is used to set the number of remote LAT service nodes for

which the Server will store information. This limit can be set in large network environments to keep Server

network overhead down.

Figure 4-6: Setting a Node Limit

Local> DEFINE SERVER NAME “Server_1”

Local> DEFINE SERVER IDENT “Biolab Server: Printer Avail-

able”

Local> DEFINE SERVER CIRCUIT 60

Local> DEFINE SERVER RETRANSMIT LIMIT 100

Local> DEFINE SERVER NODE LIMIT 5

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 222 223

Pas de commentaire

Lantronix MPS100 Guide d'installation Page 39